| | Shifting issues?? |  |
|
|
| Author | Message |
|---|
yellow660
Posts : 147
Join date : 2010-04-16
Location : Villa Rica, GA
| Subject: Shifting issues??  Wed Feb 01, 2012 11:00 pm | |
| I have a buddy who has an 08 RZR that is experiencing some shifting issues. He reports that the gears will grind sometimes when shifting through the gears and it will move in reverse without giving it gas. He did install a new belt the other day. Would this cause these issues? Thanks for any help! | |
|
| | |
badride
Posts : 1237
Join date : 2010-03-15
Age : 69
Location : Confederate States of America Fighting Terriorism since 1861
| | Subject: Re: Shifting issues?? Thu Feb 02, 2012 4:58 am | |
| Yep, the belt is too tight. | |
|
| | |
GunRunner
Admin
Posts : 5241
Join date : 2010-03-09
Age : 70
Location : North Georgia
| | Subject: Re: Shifting issues?? Thu Feb 02, 2012 10:38 am | |
| sounds like his primary clutch bearing is going bad causing it not to freewheel. | |
|
| | |
badride
Posts : 1237
Join date : 2010-03-15
Age : 69
Location : Confederate States of America Fighting Terriorism since 1861
| | Subject: Re: Shifting issues?? Thu Feb 02, 2012 11:06 am | |
| He said he just put a new belt on it. It may be too tight. I put a new belt on my S and it did the same thing. But, I had an STM so I just shimmed the secondary. | |
|
| | |
GunRunner
Admin
Posts : 5241
Join date : 2010-03-09
Age : 70
Location : North Georgia
| | Subject: Re: Shifting issues?? Thu Feb 02, 2012 2:10 pm | |
| still could be the bearing if the old belt was streched it would spin anyway | |
|
| | |
badride
Posts : 1237
Join date : 2010-03-15
Age : 69
Location : Confederate States of America Fighting Terriorism since 1861
| | Subject: Re: Shifting issues?? Thu Feb 02, 2012 2:32 pm | |
| Your right, I didn't think about that. | |
|
| | |
yellow660
Posts : 147
Join date : 2010-04-16
Location : Villa Rica, GA
| | Subject: Re: Shifting issues?? Thu Feb 02, 2012 3:03 pm | |
| Thanks guys. He did put the required Polaris belt back on the machine. If the belt is to tight, is there a way to adjust the tension or does he just need to ride it like he stole it until the belt stretches a little?  | |
|
| | |
GunRunner
Admin
Posts : 5241
Join date : 2010-03-09
Age : 70
Location : North Georgia
| | Subject: Re: Shifting issues?? Thu Feb 02, 2012 5:28 pm | |
| Sometimes you have to add or subtract shims on the secondary shaft, but usually only if you change secondary's | |
|
| | |
Sponsored content
| | Subject: Re: Shifting issues?? | |
| |
|
| | |
| | Shifting issues?? | |
|
